Home › Services › Geyser repair

Geyser repair service in Islamabad

Winter mornings in Islamabad without hot water are hard on the whole family. Saif Electrician repairs gas, electric and instant geysers at your home across Islamabad and Rawalpindi. We fix burners, thermostats, elements and leaks, and we check the gas and water fittings so the geyser runs safely. Call or WhatsApp 0333 6182150.

Geyser repair visit

Gas, electric and instant geysers, with every gas and water fitting checked.

Gas, electric and instant

All common geyser types

Repairs at your home

Islamabad and Rawalpindi

Open 24 hours

Saturday to Thursday

Friday hours

2 PM to 10 PM

What our geyser repair covers

A gas geyser depends on a small pilot flame, a thermocouple that proves the pilot is lit, a gas valve and a burner. An electric geyser depends on a heating element and a thermostat. When hot water stops, the fault is almost always in one of these parts or in the fittings around the tank.

Our technician tests each part before replacing anything and checks every gas and water joint before the geyser goes back into use. You hear the fault and the cost first, and most geyser repairs are finished in one visit.

Geyser faults we fix

Most geyser calls come in the first cold weeks of the year. These are the faults we see most, for gas and electric units alike.

Pilot light keeps going off

A dirty pilot, a weak thermocouple or low gas pressure is usually behind it. We clean the pilot assembly, test the thermocouple and replace it if needed.

No hot water from an electric geyser

The heating element or the thermostat has usually failed, or the thermostat is set wrong. We test both with a meter, replace the part that has gone and set a safe temperature.

Geyser tank leaking

Small leaks often come from the drain valve, the inlet and outlet fittings or the safety valve. A rusted tank body may need replacement, and we tell you which it is.

Burner flame weak or yellow

A blocked burner or nozzle gives a weak, yellow flame and slow heating. We clean the burner and nozzle until the flame burns blue.

Instant geyser not heating

In instant geysers the flow switch, the ignition and the gas valve or heating unit are common fault points. We test each one and repair the fault.

Electric geyser tripping the breaker

A leaking element or damaged wiring trips the breaker. We test the element insulation and the supply wire, and fix the one at fault.

A blue flame is a safe flame

A gas geyser burner should burn with a steady blue flame. A yellow or orange flame means the gas is not burning cleanly, usually because the burner, the nozzle or the air intake is blocked with dust or rust. A dirty flame heats slowly, leaves soot and can produce carbon monoxide.

We clean the burner and nozzle, check the gas pressure and confirm the flue is clear so fumes leave the house. If the flame still burns yellow after cleaning, we explain what else needs attention before the geyser is used again.

Gas geyser safety at home

A gas geyser should be installed in a ventilated place with a flue that carries fumes outside. Never run a gas geyser inside a closed bathroom, and never block the vents around it to keep the room warm.

Headaches, dizziness or a sleepy feeling while the geyser is running can be signs of carbon monoxide. Switch it off, open the windows, get everyone into fresh air and call us before using it again.

Call us before using the geyser if

If there is a gas smell, shut the gas valve and open every window before anything else. Do not switch lights on or off until the leak is found.

What a geyser check before winter includes

The right time to check a geyser is October, before the first cold night. A check covers both the heating parts and the safety parts.

Burner and pilot

The burner and pilot are cleaned so the flame lights quickly and burns blue.

Thermostat

The thermostat is tested and set to a safe temperature for daily use.

Element test

On electric geysers the element is tested for resistance and for leakage to earth.

Safety valve

The pressure relief valve is checked so the tank cannot build up too much pressure.

Fittings and joints

Inlet, outlet and gas joints are checked for drips and leaks.

Tank flush

Where scale has built up, the tank is flushed so it heats faster.

Electric geysers and your wiring

An electric geyser draws more current than almost anything else in the house. Because we are electricians, the circuit gets checked along with the geyser.

Breaker and wire size

The geyser needs a breaker and wire that match its load. Undersized ones overheat or trip.

Earthing

A metal tank full of water must be properly earthed. We check the earth connection before the geyser is used.

Never on the UPS

A home UPS cannot carry an electric geyser. Keep the geyser on the main supply only.

Geysers we repair

We work on the water heaters found in most local homes.

Gas geysers

Storage tanks heated by a gas burner, the most common type in Islamabad homes.

Electric geysers

Storage tanks heated by an element, often used where gas pressure is low.

Instant geysers

Tankless units that heat water as it flows, in gas and electric versions.

Dual geysers

Units that can run on gas or electricity, with parts for both systems.

How a geyser repair visit works

Four steps from your call to hot water.

1

Call or WhatsApp

Tell us the appliance, the brand, what it is doing and your area. A photo or short video on WhatsApp helps.

2

We set a visit time

We agree a time that suits you. From Saturday to Thursday we take calls at any hour.

3

Fault and cost first

The technician checks the appliance, explains the fault and tells you the cost before any work starts.

4

Repair and test

We fix the fault and run the appliance in front of you so you can see it working.

Geyser brands we often see

If your brand is not listed, send the model on WhatsApp and we will tell you if we can help.

Areas we cover

Our base is in Police Foundation near Bahria Phase 6, and we visit homes across Islamabad and Rawalpindi.

Geyser repair questions

Quick answers before you call. For anything else, WhatsApp us on 0333 6182150.

The pilot is usually dirty, the thermocouple is weak or the gas pressure is low. We clean the pilot, test the thermocouple and check the gas supply.

Once a year, ideally in October before winter use begins.

It can be. A yellow flame shows the gas is burning poorly, which can release carbon monoxide. Turn the geyser off and get the burner cleaned before using it again.

Usually the element has developed a leak to earth or the wiring to the geyser is damaged. Leave it off and call us so both can be tested.

Scale inside the tank, a dirty burner or a thermostat set too low are the usual causes. A yearly check and a tank flush often fix it.

Yes. We repair both gas and electric instant geysers.

No. An electric geyser draws far more current than a home UPS can supply. Keep it on the main supply only.

Yes. Cold mornings are when most geysers fail, and we are open through the night from Saturday to Thursday. On Friday we work from 2 PM to 10 PM.

Other repairs we do

No hot water?

Call or WhatsApp 0333 6182150. We are open 24 hours from Saturday to Thursday, and from 2 PM to 10 PM on Friday.